News:

Welcome to the largest gathering of Arima boat owners anywhere. We are a forum based gathering of Arima Boat enthusiasts that like to pleasure cruise, fish, camp, and hunt. While Arimas are centered in the PNW, we have members across the globe. It is 3/4's water after all. Lurk, join up, and post about your Arima upgrades, family trips, and of course, your fishing exploits. Just remember to add photos whenever possible.

Main Menu

Will 1 1/4 inch trim tab screws penetrate through the transom on a 16SC?

Started by Fisherdv, January 27, 2018, 08:59:55 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages 1 2
User actions

J Chaser

#25
January 29, 2018, 03:32:23 PM
Make sure the holes in the fiberglass are big enough, or else the screws will bind and crack the glass.

J.
Sea Chaser 1511, Yamaha F70, Yamaha F6 kicker

Fisherdv

#26
January 29, 2018, 04:41:54 PM
J., did you use the supplied screws in the kit?
2018 Sea Chaser 16, Honda BFP60

JHpls

#27
January 29, 2018, 08:22:43 PM
Was at the Seattle boat show yesterday and talked with Don about this subject. He said to make sure to ream out the hole for the screws so they are big enough, otherwise you will twist off the heads. He also said he uses 5200. Fiberglass and resin doesn't give like wood...
1995 17' Sea Ranger
2008 90hp Honda
8hp Honda

Fisherdv

#28
January 29, 2018, 08:56:52 PM
Quote from: JHpls on January 29, 2018, 08:22:43 PM
Was at the Seattle boat show yesterday and talked with Don about this subject. He said to make sure to ream out the hole for the screws so they are big enough, otherwise you will twist off the heads. He also said he uses 5200. Fiberglass and resin doesn't give like wood...
Thanks for the info JHpls
2018 Sea Chaser 16, Honda BFP60
Print
Go Up Pages 1 2
User actions