Author Topic: enlarging steering hole for hydraulic steering  (Read 133 times)

0 Members and 1 Guest are viewing this topic.

Offline skip

enlarging steering hole for hydraulic steering
« on: April 30, 2017, 09:53:01 AM »
I cut out a 6 by 6 square of 1 /2 inch plywood --drilled 3in hole in centre and drilled small holes in the centre of bolt holes as per template--screwed to dash thru small bolt holes in wanted position--used 3in hole as a guide for hole saw and then re drilled holes left by screw to proper size for bolts.
skip

Offline Croaker Stroker

Re: enlarging steering hole for hydraulic steering
« Reply #1 on: April 30, 2017, 11:38:53 AM »

Nice job. Good way to get a nice alignment for your steering.

My hole was too large.  :shrug9:
1987 - 17' Sea Pacer - 2004 Evinrude 90 E-tec
15' Sea Sprinter - **SOLD**

"If a fish will, he will… if he won't, he won't… and that's about it… except… he may take this when he won't take that."

Offline GregE

Re: enlarging steering hole for hydraulic steering
« Reply #2 on: April 30, 2017, 02:49:18 PM »
Good job.  got some pictures?

My method at the link



http://www.arimaowners.com/index.php?topic=13417.0
Greg
Osprey 26 LC Kodak;  Arima SR 19 HT; SL 22 Honda 225
http://www.sagecreekforums.com/phpforum/index.php
Sold:  Arima SE 16 WeeBait; SH 15 WeeBoat;
SR 21 NoBait;  SL 22 ReBait