ArimaOwners.com

Arima Forum => Electronics and Electrical => Topic started by: BigMac on July 11, 2017, 01:21:56 PM

Title: Perko Switch Question
Post by: BigMac on July 11, 2017, 01:21:56 PM
Need some advice about my 8-9 year old Perko Switch (the red one that has the off, 1, all, & 2 positions).
Noticing the last few months it's getting harder to dial the different positions. It catches at each position with some grating.  I've followed the recommendations that came with the switch--dial back and forth through the positions a few times.  This does seem to make the switching less hard, but only for a while. 
Time for a new switch or is there a way to correct the problem with this one?
Thanks in advance for any help/suggestions.
(Dave)


Title: Re: Perko Switch Question
Post by: Diablo on July 11, 2017, 02:28:49 PM
I'd replace it. Better to do it on the trailer than wishing you had done it at sea.
Title: Re: Perko Switch Question
Post by: Hydroman on July 11, 2017, 02:34:31 PM
I  have several friends who have recently had problems with the same switch and they had no success in repairing, I would just replace it or it will completely fail at the most inopportune time.

Jim
Title: Re: Perko Switch Question
Post by: Holoholo808 on July 11, 2017, 03:05:42 PM
Sounds like it's time to get a Blue Sea add-a-battery...

https://www.bluesea.com/products/7649/Mini_Add-A-Battery_Kit_-_65A

Title: Re: Perko Switch Question
Post by: Threeweight on July 11, 2017, 04:54:09 PM
Dave, sounds like you have some corrosion in the switch.

I'd second the Blue Sea Add a Battery suggestion.  If you don't want to go that route, a Blue Sea replacement switch. 

I think I have a brand new Blue Sea 1, 2, 1+2 switch in my garage (removed from my Hewes when I put the Add A Battery kit in it).  I'll cut you a deal on it if you want it!
Title: Re: Perko Switch Question
Post by: BigMac on July 11, 2017, 07:56:36 PM
Thanks for the good advice guys, and your offer, Steve, of a deal on the Blue Sea switch.
Probably will go back to the one being replaced.  All the holes line up, the hookups will be the same, and I'm used to using it.  The Blue Sea would be nice, but maybe as an upgrade if I rework the wiring this winter.
(Dave)
Title: Re: Perko Switch Question
Post by: Fishin Machine on July 13, 2017, 06:12:28 AM
When my Perko switch start to get hard to turn I spray some wd40 on it and it works just fine.  :beerchug:

FM